 |
 |
 |
|||||||||||||||||||||||||||||||||
For
a premium quality, deluxe single-sided roll-up banner you simply
cannot beat the CORE flip™ banner. Graphics for the CORE flip™ banner are inter-changable, just press the buttons to ‘flip’ the lid open - so when your message changes the banner doesn’t have to! CORE flip™ banners have adjustable feet, are supplied in padded bags and are available in 4 different sizes; 850mm, 1000mm, 1200mm and the giant 1500mm. |
|
||||||||||||||||||||||||||||||||||
 |
|
||||||||||||||||||||||||||||||||||
|
Grip-Rails are
available for use
with textile prints
or those that do
not bond with
adhesives. |
Optional
Adjustable Poles
allow you to adjust
your graphic to
whatever height
you want. |
Low-Voltage
Spotlights clip
to the pole
and illuminate
your graphic for
maximum impact. |
CORE flip™
banners are covered by a 5-Year Guarantee against component failure
for maximum peace of mind.
|
|
|||||||||||||||||||||||||||||||
 |
|
||||||||||||||||||||||||||||||||||
 |
|
||||||||||||||||||||||||||||||||||
 |
Chrome-plated endcaps |
 |
Click the buttons to open |
 |
Easy access to prints |
 |
Slide-in graphics |
 |
Adjustable feet |
 |
|
||||||||||||||||||||||||
 |
|
||||||||||||||||||||||||||||||||||
|
It is quite simple to install graphics into the banner
following these simple instructions. In order to replace
graphics simply carry out these steps in reverse order
to remove the original graphic. It is therefore very important that you KEEP THE LOCKING PIN in the pocket
found in the lid of the padded bag, as this will be needed to lock the tension in the Internal Roller before opening
the base. For best results ensure graphic panel media does not exceed 300 MICRONS in total thickness. |
|
||||||||||||||||||||||||||||||||||
 |
|
||||||||||||||||||||||||||||||||||
 |
Step 1: Affix Panel
Strips to the back
of the panel at the
top and bottom
with the red and
yellow tapes
ensuring panel
remains straight. |
 |
Step 2: Slide the
Banner Rail along
the Panel Strip
at the top of the
panel as shown.
Secure the Banner
Rail with tape if
desired. |
 |
Alternatively if
using Grip Rails:
Simply open the
profile and slide
top of the graphic
in as shown. Press
down hard to close
the profile. |
 |
Step 3: Press the
blue buttons at
each end of the
banner to ‘flip’
open the lid and
carefully remove
the Internal Roller
from the base. |
 |
Step 4: Slide the
Internal Roller on
to the bottom of
the graphic. Return
the roller into the
base ensuring the
indented section is
facing upwards. |
 |
Alternatively
if using Grip
Roller: Open Grip
Roller profile and
slide graphic in as
shown. Press down
hard to close the
profile. |
 |
Step 5: Close the
lid and pull out
the locking pin
at one end of the
banner, allowing
the graphic to
gently retract into
the base. |
 |
|
||||||||||||||||||||
 |
|
||||||||||||||||||||||||||||||||||
 |
|
||||||||||||||||||||||||||||||||||
 |
|
||||||||||||||||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Copyright ©2007 CORE Display Systems Ltd.